|
我的程序DMA采样循环模式,配置如下:
DMA_InitStructure.DMA_PeripheralBaseAddr = ADC1_DR_Address;
DMA_InitStructure.DMA_MemoryBaseAddr = (u32)&ADCConvertedValue;
DMA_InitStructure.DMA_DIR = DMA_DIR_PeripheralSRC;
DMA_InitStructure.DMA_BufferSize = 80;//40sample为1半
DMA_InitStructure.DMA_PeripheralInc = DMA_PeripheralInc_Disable;
DMA_InitStructure.DMA_MemoryInc = DMA_MemoryInc_Enable;
DMA_InitStructure.DMA_PeripheralDataSize = DMA_PeripheralDataSize_HalfWord;
DMA_InitStructure.DMA_MemoryDataSize = DMA_MemoryDataSize_HalfWord;
DMA_InitStructure.DMA_Mode = DMA_Mode_Circular;
DMA_InitStructure.DMA_Priority = DMA_Priority_High;
DMA_InitStructure.DMA_M2M = DMA_M2M_Disable;
DMA_Init(DMA1_Channel1, &DMA_InitStructure);
DMA_ITConfig(DMA1_Channel1,DMA_IT_TE,DISABLE);
DMA_ITConfig(DMA1_Channel1,DMA_IT_HT|DMA_IT_TC,ENABLE);
ADC连续扫描,规则通道,配置如下:
/* ADC1 configuration ------------------------------------------------------*/
ADC_InitStructure.ADC_Mode = ADC_Mode_Independent;
ADC_InitStructure.ADC_ScanConvMode = ENABLE;
ADC_InitStructure.ADC_ContinuousConvMode = ENABLE;
ADC_InitStructure.ADC_ExternalTrigConv = ADC_ExternalTrigConv_None;
ADC_InitStructure.ADC_DataAlign = ADC_DataAlign_Right;//右对齐
ADC_InitStructure.ADC_NbrOfChannel = 8;
ADC_Init(ADC1, &ADC_InitStructure);
请教版主及各位大侠:
1.ADC每采样完一个数据后,是立刻就通过DMA传输到ADCConvertedValue,还是等采集到我设定的数据长度80或一半(即40)的数据后,再传到ADCConvertedValue?
2.在存放到ADCConvertedValue时,是按地址增量方式,即从ADCConvertedValue【0】到ADCConvertedValue【80】这么存的么?也就是最新的数据是在ADCConvertedValue【80】?
|
|