在系统建立后:由如下提示信息
reating rom file C:\WINCE500\PBWorkspaces\ep9312\RelDir\ep931x_ARMV4I_Release\NK.nb0
Done!
makeimg: Check for C:\WINCE500\PBWorkspaces\ep9312\RelDir\ep931x_ARMV4I_Release\PostRomImage.bat to run.
makeimg: Check for C:\WINCE500\PBWorkspaces\ep9312\RelDir\ep931x_ARMV4I_Release\PostMakeImg.bat to run.
makeimg: Change directory to C:\WINCE500.
makeimg: run command: cmd /C C:\WINCE500\public\common\oak\misc\pbpostmakeimg
驱动器 C 中的卷没有标签。
卷的序列号是 A804-FC70
C:\WINCE500\PBWorkspaces\ep9312\RelDir\ep931x_ARMV4I_Release 的目录
2007-07-10 16:18 374,527 NK.bin
1 个文件 374,527 字节
0 个目录 957,022,208 可用字节
BLDDEMO: ep9312 build complete.
ep9312 - 0 error(s), 2 warning(s)
通过以太网下载到目标板后无法启动系统.
在串口提示如下信息:
Sent BOOTME to 255.255.255.255
Locked Down Link 1
Src IP 192.168.1.201 Port 0800 Dest IP 192.168.1.108 Port 0C88
EthDown::TFTPD_OPEN::boot.bin
-EbootSendBootmeAndWaitForTftp
Found pTOC signature.
ROMHDR at Address 00200044h
RomHdr.ulRAMStart=82000000h RomHdr.physfirst=80200000h.
Got EDBG_CMD_JUMPIMG
Got EDBG_CMD_CONFIG, flags:0x00000000
EBOOT: pCfgData = 0x5F16A, pCfgData->Flags
INFO: Jumping to image at 0x00201006...
Windows CE Kernel for ARM (Thumb Enabled) Built on Jun 24 2004 at 18:25:00
ProcessorType=0920 Revision=0
sp_abt=ffff5000 sp_irq=ffff2800 sp_undef=ffffc800 OEMAddressTable = 80201150
InitClock...
Processor = 199Mhz, Bus = 99Mhz
Sp=ffffc7cc
在PB中提示如下的信息:
The Kernel Debugger is waiting to connect with target.
请问问题出在哪里?好久都没有解决了,郁闷中。请给指条明路。